Side bar of a Display

The sidebar of each single display is a detailed information panel that gives additional information on the currently selected item, in this example there is additional information about the display.


Click on the arrow on the right side of the page to access the side bar.



Detailed Information on the side bar of the display:


  1. Serial number: Shows the serial number of the display , 
  2. Display Type: Shows the type of  the display and the number of pixels in brackets.
  3. Lay out Name: Shows the name of the Layout .
  4. Last communicator: Shows to which communicator is this display connected.
  5. Last Battery Status: Shows the current battery status off the display. Under the status also shows the battery voltage level which really helps the user know the battery level.
  6. Last temperature: Shows the last temperature of the display when its updated.
  7. Summarized status: Shows the status of the display
  8. Preview: Click the link to see what is shown on the display. . It opens a new window where it shows how the display looks like and the details of the display.

    Extended:
  9. Last health check status: Shows whether its Good, unknown or Failed communication. This can be updated by 'Ping' function  (right click on display and select 'Ping')
  10. Last health check up successed at: Shows the exact day and time
  11. RF Address : Only for support use.
  12. Configuration Time: Shows the date and time when the display is configured.
  13. Firmware : It shows the latest firmware the display has.


Common Status messages: 


1. Failed radio coverage check:

The display is out of range of the antennas or is unable to get in contact with the antenna.

Solution: Make sure the display is in range off an antenna, Force update the display.

 

2. Failed to network configure display:

When the display is added to the system the system will network configure the display. If this network configure fails the display will recieve the message.

Solution: Place the display near the main antenna and Reconfigure the display.

 

3. Product does not exist:

If the product attached to the display does not exist in the Breece database. 

Solution: Make sure the product is loaded into Breece. You can check this in the products tab.

 

4. Low battery:

When the display is about to run out of battery.

Solution:

The displays will show one of these icons.

Displayed when the display has low battery. Change the battery.


Displayed when the display is mounted in a cool area below the recommended limit. Move the display to a new location where the temperature is in the recommended range. Wait for the display to warm up and try force updating the display.

Top bar