If you use a smartphone or handheld scanner to add displays to the system,

Do you need to ensure that you have the button "Add displays" and "Delete displays" on your Breece Mobil Assist app. 

(If you do not have these buttons in the BMA app - contact your own support to have them added).


Add display to the BMA System

1. Find the main antenna in the store. It is marked with an orange sticker on the antenna.

2. Place displays as close to the main antenna as possible. This is important to achieve the best result.

3. Press the add button in the BMA app.

4. Scan the displays you need to add to the system




You can follow the display queue on the website under Jobs



5. Make sure the queue is empty before proceeding.

The displays that have been changed and have the store logo are on, you can now use them in the store.

If there are faulty displays that are still blank or have the old store's logo on - go on to the next step




Delete displays from the BMA system

1. Find the failed displays.

2. Select "Delete display" in the BMA app.

3. Scan the failed displays.

4. Check that the job queue is empty after you have scanned all the displays to be deleted.

5. Select "Add display".

6. Scan the displays you need to add to the system

We recommend doing this a maximum of 3 times on displays.

 

 

 

If displays still do not work, you can do the following

1. Try removing the battery from the display for about 10 seconds and inserting it back in. Then try deleting and adding the display again.

2. Remember to delete displays on the system before adding the display

3. If the display still does not work, you can try to configure the battery.

4. If the display still fails, the display must be broken and can be sent back to Delfi Technologies  on disposal.




Add displays via cloud.breecesystem.com

Here you need to make sure you have a barcode scanner, if you need to scan many otherwise you can enter them manually

Log in to your cloud installation.


2. Touch the "Displays" click 

3. In the lower left corner, click

4. Scan displays directly into the cloud - Tap inside the square and scan your displays

• or scan displays into notepad and save the file

  • press then     find the file you just saved and then press "Upload".



5. When done, press

6. Now displays will be added

7. You can follow the jobs queue by tapping the tab

8. Check that the queue is empty before proceeding

9. The displays that have been changed and have the store logo, you can now use in the store.

• If there are faulty displays that are still blank or have the old store's logo on - go on to the next step.

 

 

 

Delete displays from the system

1. Find the failed displays.

2. Select the delete button

3. Scan the faulty display (as in the "Add displays" section, points 3-5).

4. check that the jobs queue is empty after you have scanned all the displays to be deleted.

5. Press the add button.

6. Scan the displays you need to add to the system (as in the "Add displays" section, item 3-5).

We recommend doing this a maximum of 3 times on displays. Subsequently, a battery change may work otherwise the display is broken.

 

If displays still do not work, you can do the following

  1. Try removing the battery from the display for about 10 seconds and inserting it back in. Then try deleting and adding the display again.
  2. Remember to delete displays on the system before adding the display
  3. If the display still does not work, you can try writing the battery.
  4. If the display still fails, the display must be broken and can be sent back to Delfi Technologies mbh. on disposal.